Aileron Servo Installation - E-FLITE Taylorcraft 450 ARF Assembly Manual

Aileron Servo Installation

Required Parts
Wing w/ailerons (R&L)
Micro pushrod connector (2)
Servo mounting plate (R&L)
Sub-micro servo (2)
6-inch (152mm) servo extension (2)
2mm x 4mm machine screw (2)
2mm x 6mm sheet metal screw (8)
Pushrod wire, 3 3 -inch (95mm) (2)
/
4
5/16 x 5/16 x 1/2-inch (8 x 8 x 12mm) mounting block (4)
Required Tools and Adhesives
Pin drill
Side cutters
Pencil
#1 Phillips screwdriver
  1. Use a pin drill and 1/16-inch (1.5mm) drill bit to
enlarge the outer hole in a medium length servo arm.
8
Servo arm (medium length)
Pushrod connector backplate (2)
Control horn (2)
Y-harness
Drill bit: 1/16-inch (1.5mm)
String
6-minute epoxy
Low-tack masking tape
  2. Slide a micro pushrod connector into the hole drilled
in the previous step.
  3. Use a pushrod connector backplate to secure the
connector to the servo arm.
  4. Use side cutters to remove the remaining arm so it
won't interfere with the operation of the servo.
E-flite Taylorcraft ARF Assembly Manual