E-TON sport 50 Service Manual page 78

6. CYLINDER HEAD/VALVE
Install the lock pins.
Install the camshaft holder, gasket and nut
onto the cylinder head.
Tighten the cylinder head nuts. (4 nuts)
At first, tighten the 4 nuts on the cylinder top
and then tighten the 2 bolts on the left side of
cylinder head.
Torque value: 1.0~1.4 kgf-m
Install the spark plug and tighten it.
Torque value: 1.0~1.4 kgf-m
Caution
Apply with oil onto the thread of cylinder
head bolts and tighten the bolts in
diagonally for 2-3 sequences.
Do not over tightening the bolts to avoid
the cylinder head deformation, noise
created or leaking so that effects
motorcycle's performance.
VALVE CLEARANCE ADJUSTMENT
Loosen valve clearance adjustment nuts and
bolts located on valve rocker arm.
Measure and adjust valve clearance with
feeler gauge.
After valve clearance had been adjusted to
standard value, hold adjustment bolt and
then tighten the adjustment nut.
Standard Value: IN/EX 0.06 0.02mm
Turn the cam chain adjuster in clockwise
motion so that the adjuster is pushed out to
contact the cam chain plate tightly. Tighten
the bolt cap of the adjuster adjustment hole.
Caution
The O-ring must be installed into glove.
Replace the O-ring of the cylinder head with
new one. Install the cylinder head.
Tighten the cylinder head lock bolts.
Connect the blow-by hose onto the cylinder
head.
nd
Tighten the 2 air injection (AI) nut.
Install the engine onto the engine frame.
(Refer to Chapter 5)
6-14
pin
holder
Especial tool
Blow-by hose
A.I
E-TON
bolt
4 bolts