E-TON sport 50 Service Manual page 14

E-TON
Do not let the wire harness contact with
rotating, moving or vibrating components as
routing the harness.
Keep wire harnesses far away from the hot
parts.
Route wire harness to avoid sharp edges or
corners and also avoid the projected ends of
bolts and screws.
Route harnesses so that they neither pull too
tight nor have excessive slack.
Do not extend
it too much.
1. GENERAL INFORMATION/TROUBLE DIAGNOSIS
Do not touch it.
Protect wires or wire harnesses with electrical
tape or tube if they contact a sharp edge or
corner. Thoroughly clean the surface where
tape is to be applied.
Secure the rubber boot firmly as applying it
on wire harness.
Never use wires or harnesses which
insulation has been broken. Wrap electrical
tape around the damaged parts or replace
them.
Never clamp or squeeze the wire harness as
installing other components.
Please do not clip or
squeeze the wire.
1-7