Dell OptiPlex SX270 User Manual page 70

1 drive connector
2 drive cable
15. Slide the drive into the drive bay and lower the hard-drive door to lock into place.
16. Replace the cable cover (if used).
17. Attach the computer to the mounting plate (if used).
NOTICE: To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.
18. Connect your computer to the power adapter and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
19. Reboot the computer.
20. Partition and logically format your drive before you proceed to the next step.
For instructions, see the documentation that came with your operating system.
21. Test the hard drive by running the
22. Install your operating system on the hard drive.
For instructions, see the documentation that came with your operating system.
After you replace the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next computer
start-up:
ALERT! Cover was previously removed.
23. Reset the chassis intrusion detector
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis
intrusion detector.
Back to Contents Page
Dell Diagnostics.
by changing Chassis Intrusion to Enabled or Enabled-Silent.