IMPORTANT NOTICE FOR USE IN HEALTHCARE ENVIRONMENTS: Dell products are not medical devices and are not listed under UL or IEC 60601 (or equivalent). As a result, they must not be used within 6 feet of a patient or in a manner that directly or indirectly contacts a patient 1.1 SAFETY: General Safety...
Page 4
When operating your equipment: Do not use your equipment in a wet environment, for example, near a bath tub, sink, or swimming pool or in a wet basement. Do not use AC powered equipment during an electrical storm. Battery powered devices may be used if all cables have been disconnected.
If your equipment uses an AC adapter: Use only the Dell provided AC adapter approved for use with this device. Use of another AC adapter may cause a fire or explosion. NOTE: Refer to your system rating label for information on the proper adapter model approved for use with your device.
4. Prepare the implement, equipment, material as bellow: 1) Working table 2) Screw-driver 3) Gloves 4) Cleaning cloth 5) ESD protection 6) S2422HGB Curve Sponge Jig Item Picture Operation Tool Notes To remove the stand:...
Page 7
1. Use hands or Scraper bar scraper bar to disassemble Rear Cover from monitor Notice the disassembly order: Top Side=>Right/ Left Side=>Bottom Side 2. Remove “CTRL BD FFC” from I/F BD and tear off it from Main SHD to take off Rear Cover 1.
Page 8
1. Remove Mylar from SPS BD 1. Unlock 8 PCBA Screw-driver screws (Torsion of screw: 8.5±1.0kg) 1. Disassemble I/F BD from Main SHD and remove SPS BD wire from I/F BD 2. Disassemble SPS BD from Main SHD 3. Remove “LVDS FFC cable”...
3. Assembly SOP Preparation before assemble 1. Clean the room for work 2. Identify the area for material 3. Prepare the implement, equipment, material as bellow: 7) Working table 8) Screw-driver 9) Glove 10) Cleaning cloth ESD protection Item Picture Operation Tools Notes...
Page 10
Panel and 1. Place Panel on S2422HGB whole S2422HGB Curve Curve monitor Sponge Jig Sponge Jig head must be put on S2422HGB curve sponge jig to avoid panel damage. 2. Insert “LVDS FFC cable” It is not and “WIRE 6P/10P” into...
Page 11
1. Follow the order to assemble Rear Cover with Middle Frame Lock 4 RC screws Screw- driver (Torsion of RC screw: 8~10Kg) Assemble stand with monitor head: 1. Align and place the stand riser on the stand base. 2. Open the screw handle at the bottom of the stand base and turn it clockwise to secure the stand...