Dell OptiPlex SX270 User Manual page 18

1 release lever tab
2 mounting plate slot
3 screw holes (4)
4 solid surface with a 1-inch (2.5 cm) minimum thickness
CAUTION: Attach the mounting plate to a solid surface capable of supporting 40 lbs (18.1 kg) hanging weight.
1. Using the four #6 wood screws (0.625 inch; 15.88 mm) provided, attach the mounting plate to a solid surface with a minimum thickness of 1 inch (2.5
cm).
2. Orient the computer and stand under the mounting plate approximately 1 inch (2.5 cm) from the edge of the mounting plate.
3. Lift the computer and stand, insert the stand into the mounting bracket, and slide the stand until the release lever tab is inserted through the slot in
the mounting plate.
4. Attach the cable cover (if used).
Removing the Computer From the Mounting Plate
1 mounting plate slot
2 release lever tab
CAUTION: To avoid personal injury, remove the mounting plate if you are permanently removing the computer.
1. Firmly hold the computer and press the release lever tab until the tab is freed from the slot on the mounting plate.