Spark Plug; Cooling System Cleaning - Echo SRM-211SB Operator's Manual

WARNING
Catalytic mufflers operate at extremely high temperatures. Muffler
area must be kept clean. Do not perform maintenance on the muffler
until engine and muffler are completely cool, otherwise serious
personal injury may occur.

SPARK PLUG

Level 2.
Tools required: Scrench (combination socket wrench and screwdriver),
Feeler gauge (preferably a wire gauge) , Brush.
Parts Required: 90064 REPOWER
1. Remove spark plug and check for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 145-155 kg/cm (125-135 in. lb.).
COOLING SYSTEMS CLEANING
Level 2.
Tools required: Cross Head Screwdriver, 3 mm Hex Wrench, Pointed
Wood Stick, Cleaning brush (25 or 50 mm [1 or 2 in.] medium bristle
paint brush).
Parts Required: None if you are careful.
IMPORTANT
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fin area. This flow of air carries
combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the
cylinder.
• Dust and grass build up on the outside of the cylinder. This build up
insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages or cleaning of cooling fins is
considered "Normal Maintenance". Any failure attributed to lack of
maintenance is not warranted.
G
DANGER
TM
TUNE-UP KIT
T /B
RASS RIMMER
O
PERATOR
C
RUSH UTTER
' M
S ANUAL
0.65 mm
(0.026 in.)
27