Plastic Shield Installation; Nylon Line Head Installation - Echo SRM-211SB Operator's Manual

5. Rotate locator pin (B) 1/4 turn clockwise to engage lower drive shaft
hole. Insure locator pin is fully engaged by gently twisting lower
drive shaft. Locator pin should snap flush in coupler. Full engage-
ment will prevent further shaft rotation.
6. Secure lower shaft assembly to coupler (C) by tightening clamping
knob (A).

PLASTIC SHIELD INSTALLATION

(For Nylon Line Operation)
Tools Required: Screwdriver.
Parts Required: Plastic Shield, Shield Plate, three (3) 5 mm x 15 mm
screws.
NOTE
The plastic shield is for use with the Nylon Line Head only. Install
Metal Shield when using plastic or metal blades.
1. Remove plastic threaded shaft sleeve and adapter plate (A) from
PTO shaft.
2. Place the shield on the bottom of the bearing housing flange.
3. Place shield plate (B) on shield, align holes. Install three (3) screws
from bottom through plate and shield into gearcase.
4. Assemble adapter plate (A) onto PTO shaft.

NYLON LINE HEAD INSTALLATION

Tools Required: Head Locking Tool
Parts Required: Nylon Line Head.
1. Be sure adapter plate (A) remains on PTO shaft.
2. Align locking hole in adapter plate (A) with notch in edge of gear
housing and insert head locking tool (C).
3. Thread line head onto P.T.O. shaft by turning it counter clockwise
until head is tight against adapter plate (A).
4. Remove locking tool (C).
G T
RASS RIMMER
O
PERATOR
A
/B C
RUSH UTTER
' M
S ANUAL
B
C
A
B
C
15