Flowcharts - Olivetti d-Copia 3501 Service Manual

[6] UNPACKING AND INSTALLATION

1. Flowcharts

I I nstalling procedure flowchart - d-Copia 351
For installing option units, observe the following procedures
for efficiency.
To install the devices effciently, follow the procedure below.
Some peripheral devices may have been installed as standard
devices depending on the main unit model.
Part of descriptions and illustrations may be different.
Duplex/bypass device
Start of installation
Main unit, paper feeding
device, and power supply
unit.
AR-D27
Main unit
Yes
Duplex/bypass
device installed?
No
Yes
Finishing device
installed?
No
For installation of an option unit, refer to the Service Manual of the option unit.
∗
Y105220-6
Scanner/document feeder device
Main
unit
Paper feeding device
[Electrical setting/adjustment]
Install duplex/pypass device.
1) Installation of driver software, setting,
AR-DU4
2) Paper guide position adjustment/off center adjustment
Install finishing device.
AR-FN6
Sevice Manual
Finishing device
Controller board,
facsimile unit or other
electric devices
installed?
No
and operation check
Main unit/AR-EF3
AR-D27
AR-DU4
End
When installing a paper feeding device or a duplex/bypass device, be sure to reattach
the rear cabinet, the AC inlet cover, and the harness cover of the main unit at the end
of installation as needed.
Install controller board,
facsimile unit or other electric
devices.
Yes
AR-NC8
6-1