Olivetti d-Copia 3501 Service Manual page 172

Since this simulation cannot change the Fax destination, use SIM
66-2 to change the FAX destination.
SIMULATION 26-6
DESTINATION SETUP. SELECT 1-10, AND PRESS START.
1.USA 2.CANADA 3.INCH
4.JAPAN 5.AB_B
6.EUROPE 7.UK 8.AUSTRALIA
9.AB_A 10.CHINA
26-10
Setting
Purpose
Used to set the network scanner trial mode.
Function
(Purpose)
Operation
Item
Operation/Procedure
1) Select START/END of the network scanner trial mode with 10-
key.
2) Press [START] key.
Max. 500 menus can be scanned.
0 END Trial mode cancel
1 START Trial mode start
SIMULATION 26-10
NETWORK SCANNER TRIAL SETTING. SELECT 0-1, AND PRESS
START.
0.END
1.START
26-18
Setting
Purpose
Used to set YES/NO of toner save operation. (This
Function
function is valid only in Japan and UK versions.
(Purpose)
(Depends on the destination setting of SIM26-6.)
For the other destinations, the same setting can
be made by the user program P22.)
Specifications
Item
Operation/Procedure
1) Select YES/NO of the toner save mode with 10-key.
2) Press [START] key.
0 YES Toner save mode is set.
1 NO Toner save mode is not set.
SIMULATION 26-18
TONER SAVE MODE SETTING. SELECT 0-1, AND PRESS START.
0. YES
1. NO
26-30
Setting
Purpose
Used to set the operation mode conforming to the
Function
CE mark (Europe safety standards). (Conforming
(Purpose)
to soft start when driving the fusing heater lamp.)
Specifications
Item
Operation/Procedure
1) Select the number corresponding to the operation mode with
10-key.
2) Press [START] key.
0 NO CE mark control NO (Normal operation)
1 YES CE mark control YES (Heater lamp soft start
operation)
Y105220-6
1
Default
1
Operation mode
Default
1
Operation mode (Common)
Sevice Manual
(Default: 1 for Europe, 0 for the others)
SIMULATION 26-30
CE MARK CONTROL SETTING. SELECT 0-1, AND PRESS START.
0. NO
1. YES
26-35
Setting
Purpose
Used to set whether the same continuous troubles
Function
are displayed as one trouble or the series of
(Purpose)
troubles with SIM 22-4 when the same troubles
occur continuously.
Section
Specifications
Item
Operation/Procedure
1) Select the number corresponding to the operation mode with
10-key.
2) Press [START] key.
0 ONCE When two or more troubles of a same kind occur
continuously, the troubles are displayed as one
trouble in the trouble history of SIM22-4.
1 ANY When two or more troubles of a same kind occur
continuously, the troubles are displayed straightly
as two or more troubles in the trouble history of
SIM22-4.
(Default: 0)
SIMULATION 26-35
TROUBLE MEMORY MODE SETTING. SELECT 0-1, AND PRESS
START.
0. ONCE
1. ANY
26-38
Setting
Purpose
Used to set CONTINUE/STOP of printing when
Function
maintenance timing is over and the count value
(Purpose)
reaches 110% of replacement timing (life).
Other
Section
Specifications
Item
Operation/Procedure
1) Select the number corresponding to the operation mode with
10-key.
2) Press [START] key.
0 PRINT CONTINUE
1 PRINT STOP
(Default: 0)
SIMULATION 26-38
LIFE OVER SETTING. SELECT 0-1, AND PRESS START.
0. PRINT CONTINUE
1. PRINT STOP
1
1
Print continue
Print stop
1
9-29