Dell Inspiron 3500 Reference And Troubleshooting Manual page 33

2-2 Dell Inspiron 3500 Portable Computer Reference and Troubleshooting Guide
‡
Adjust audio properties
In Windows 98, click the Start button, point to Settings, and then click Control
Panel. Double-click the Multimedia icon. Alternatively, right-click the Audio icon
in the taskbar.
‡
Customize touch pad and cursor features
In Windows 98, click the Start button, point to Settings, and then click Control
Panel. Double-click the Mouse icon.
For more information, see the topic titled "Touch Pad" in the System User's
Guide .
‡
Check battery status
In Windows 98, see the operating system documentation for instructions on
using the battery status utility that comes with the operating system.
‡
Manage power consumption when using a battery
For more information about saving battery power, see the topic titled "Conserv-
ing Battery Power" in the System User's Guide .
6HWXS3URJUDP 
Your computer retains system configuration information in the nonvolatile random-
access memory (NVRAM) maintained by your computer's backup battery. Each time
you turn on your computer, the system compares the installed hardware with the sys-
tem configuration information stored in NVRAM. If the system detects a discrepancy,
it generates an error message that identifies the incorrect configuration setting. The
system then prompts you to enter the Setup program to correct the setting.
You can use the Setup program as follows:
‡
To change your system configuration information after you add, change, or
remove hardware connected to or installed inside your computer
‡
To verify information about your computer's current configuration, such as the
amount of system memory
‡
To set or change user-selectable features — for example, power management or
security features
NOTE: Many of the settings that are configured in the Setup program are over-
ridden by the settings in the Windows control panels, such as the Power
Management control panel. When your computer is running the Windows oper-
ating system, it will use the settings that are selected in the Windows control
panels rather than those set in the Setup program.