Play/Pause Mode; Program Mode - Hyundai H-1427 Instruction Manual

Instruction manual
close the CD door.
Playing USB devices
• Set FUNCTION switch to CD/USB position.
• Insert a USB device into the USB slot.
• Press and hold CD/USB/
• All other operations for USB are the same
as for disc playback.

Play/pause mode

• Press CD/USB/
• Press CD/USB/
track when playing. Press the button again to
resume.
• To stop playback, press
• To remove the CD from the unit open
the CD door. Always press
opening the CD compartment.
• To turn off the CD player set FUNCTION
switch to TAPE position.
Skip and search mode
During playback you can use
to go to previous or next track.
• If you have selected a track number in
the stop or pause position, press CD/USB/
button to start playback.
• Press button once briefly for the next
track, or press repeatedly until the needed
track number is displayed.
• Press button once briefly to return to
the beginning of a current track.
• Press button more than once briefly for
a previous track.
Fast backward/ forward playback
Press and hold /
backward or forward playback until you find the
passage to play from.
Play modes
While playing Audio CD:
• Press PLAY MODE button once for single
track repeat playing.
• Press PLAY MODE button twice for all
tracks repeat playing.
4
button.
button to start playback.
button to pause at any
button.
button before
/ buttons
buttons to start fast
• Press PLAY MODE three times for playing
randomly.
• Press PLAY MODE four times for normal
playing.
While playing MP3:
• Press PLAY MODE button once for single
track repeat playing.
• Press PLAY MODE twice for track inside
the album repeat playing.
• Press PLAY MODE three times for all
tracks repeat playing.
• Press PLAY MODE four times for playing
randomly.
• Press PLAY MODE five times for normal
playing.

Program mode

Up to 32 tracks can be programmed for disc
play in any order or the same track can be
repeated several times. Before programming,
press button.
• Press PROG button. "P01" and "PROG"
will blink. For MP3/WMA discs containing
folders, press PROG button then
select a folder.
• Select a desired track by using
buttons.
• Press PROG button to confirm.
• Repeat two last steps described above to
enter additional memories into the program if
necessary.
• Reviewing the programm: after playing at
least one programmed track, press
button; the display will show the memorized
track numbers.
• When all the desired tracks have been
programmed, press CD/USB/
the disc in the order you have programmed.
You can erase the contents of the
memory by one of the following methods:
- opening the CD door;
- selecting RADIO or TAPE source.
Good quality sound is guaranteed
only when playing licensed discs. Besides,
depending on the disc brand or the burning
speed some reding problems may occur.
button to
/
or
button to play