Play/Pause Mode; Program Mode - Hyundai H-1437 Instruction Manual

Instruction manual

Play/pause mode

• Press CD/USB button to start playback.
• Press CD/USB button to pause at any
track when playing. Press the button again to
resume.
• To stop playback, press
• To remove the CD from the unit open
the CD door. Always press
opening the CD compartment.
Skip and search mode
During playback you can use
to go to previous or next track.
• Press button once briefly for the next
track, or press repeatedly until the needed
track number is displayed.
• Press button briefly to go to the
previous track.
• For MP3 disc or USB device containing
folders, press and hold FOLDER/+10 button,
then press this button repeatedly to select
needed folder.
Fast backward/forward playback
Press and hold /
backward or forward playback until you find the
passage to play from.
Play modes
While playing Audio CD:
• Press PLAY MODE/PROGRAM button
once for single track repeat playing.
• Press PLAY MODE/PROGRAM button
twice for all tracks repeat playing.
• Press PLAY MODE/PROGRAM three
times for playing randomly.
• Press PLAY MODE/PROGRAM four times
for normal playing.
While playing MP3:
• Press PLAY MODE/PROGRAM button
once for single track repeat playing.
• Press PLAY MODE/PROGRAM twice for
all tracks repeat playing.
• Press PLAY MODE/PROGRAM three
times for current folder repeat playing.
• Press PLAY MODE/PROGRAM four times
for playing randomly.
4
button.
button before
/ buttons
buttons to start fast
• Press PLAY MODE/PROGRAM five times
for normal playing.

Program mode

Up to 32 tracks can be programmed for disc
play in any order or the same track can be
repeated several times. Before programming,
press button.
• Press PLAY MODE/PROGRAM button.
"P01" and "PROG" will blink.
• Select a desired track by using
buttons.
• Press PLAY MODE/PROGRAM button to
confirm.
• Repeat two last steps described above to
enter additional memories into the program if
necessary.
• Reviewing the programm: in stop mode,
press or button; the display will show
the memorized track numbers.
• When all the desired tracks have been
programmed, press
the disc in the order you have programmed.
You can erase the contents of the
memory by one of the following methods:
- opening the CD door;
- pressing button twice;
- selecting RADIO source.
Good quality sound is guaranteed
only when playing licensed discs. Besides,
depending on the disc brand or the burning
speed some reding problems may occur.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
/
CD/USB button to play