Tube Fitting Connections Assembly [24] - Sea Recovery Aqua Mini 170 Owner's Manual

WRONG
BEND TOO TIGHT
NO SLACK
1. Connect all inlet feed lines with the supplied 20 feet (6 meters) of 1/2" (12.7 mm) I.D. Inlet Suction Hose:
Outlet of
Sea Cock Valve [2]
Sea Strainer [3]
Inlet 3-way Clean/Rinse Valve [30]
Inlet 3-way Clean/Rinse Valve [30]
Booster Pump [4]
Fresh Water Flush Check Valve [26]
Plankton Filter [5]
Prefilter [6]

Tube Fitting Connections Assembly [24]

1. Cut tube end square and clean.
2. Loosen nut on fitting three turns.
3. Insert tube into fitting until it bottoms. Loosen nut completely and remove tube with attached parts from body.
Check to ensure that the O-Ring is seated onto the tube under the spacer (and not pinched into the body).
Insert tube with attached parts into the body and tighten nut finger tight.
32
CORRECT
HOSE EXITS FITTING
STRAIGHT FOR
SEVERAL INCHES
RELAXED BEND
WITH SLACK
to Inlet of
Sea Strainer [3]
Inlet 3-Way Clean/Rinse Valve [30]
Rinse/Clean bucket or container
Booster Pump [4]
Fresh Water Flush Check Valve [26]
Plankton Filter [5]
Prefilter [6]
High Pressure Pump [11]
Sea Recovery Aqua Mini 170, 350, 550 and 750