Servicing The Spark Plug - Toro CCR 6053 R Quick Clear Operator's Manual

1. Using SAE 30 at outdoor
temperatures below 40°F
(4°C) will result in hard
starting.
Note: 0W30 synthetic oil is acceptable for use in
cold temperatures.
9. Screw the oil fill cap into the oil fill hole, and hand
tighten it securely.
10. Wipe up any spilled oil.
11. Dispose of the used oil properly at a local recycling
center.

Servicing the Spark Plug

Service Interval: Yearly—Service the spark plug and
replace it if necessary.
Use a NGK BPR6ES or Champion RN9YC spark
plug or equivalent.
1. Stop the engine and wait for all moving parts to stop.
Figure 31
2. Using 10W-30 at outdoor
temperatures above
80°F (27°C) may result in
increased oil consumption;
therefore, check the oil
level more frequently in
these circumstances.
Figure 32
2. Rotate the discharge chute so that it faces forward.
3. Remove the discharge chute, the discharge chute
handle, and the chute seal by removing the 3 large
screws and one small screw (Figure 33).
1. Fuel tank cap
2. Large screws (3)
3. Discharge chute
4. Remove the 4 screws that secure the shroud
(Figure 34).
1. Screw (4)
2. Shroud
16
Figure 33
4. Small screw
5. Chute seal
Figure 34
3. Spark plug
4. Spark-plug wire