Toro CCR 6053 R Quick Clear Operator's Manual page 10

1. Choke lever
3. Firmly push in the primer with your thumb 3 times
(0°F or -18°C or above) or 6 times (0°F or -18°C or
below), holding the primer in a for a second before
releasing it each time (Figure 15 and Figure 16).
1. Symbols on the choke lever indicating to move the choke
lever to the left to activate the choke.
Figure 14
Figure 15
Figure 16
Note: Remove your glove when you push in the
primer so that air cannot escape from the primer
hole.
Important: Do not use the primer or the choke
if the engine has been running and is hot.
Excessive priming may flood the engine and
prevent it from starting.
4. Connect an extension cord to a power source and
the machine, and push the electric-start button
(model 38569 only) (Figure 17), or pull the recoil
start handle (Figure 18).
Note: Use only a UL-listed, 16-gauge extension
cord recommended for outdoor use that is not
longer than 50 feet (15 m).
WARNING
The electrical cord can become damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
plugging it into a power source. If the
cord is damaged, do not use it to start the
machine. Replace or repair the damaged cord
immediately. Contact an Authorized Service
Dealer for assistance.
10
Figure 17