Adjusting The Discharge Chute And Chute Deflector; Preventing Freeze-Up After Use - Toro CCR 6053 R Quick Clear Operator's Manual

Adjusting the Discharge Chute
and Chute Deflector
To adjust the discharge chute, press the trigger of the
Quick Shoot™ control on the right hand side of the
handle and move it up or down along the handle. Moving
the control down the handle rotates the discharge chute
to the left; moving the control up the handle rotates the
discharge chute to the right (Figure 22).
To raise or lower the angle of the chute deflector, press
the trigger on the chute deflector and move the chute
deflector up or down (Figure 23).
1. Chute deflector trigger
Figure 22
Figure 23
2. Chute deflector
Clearing a Clogged Discharge
Chute
Important: Hand contact with the rotating rotor
blades inside the discharge chute is the most
common cause of injury associated with snow
throwers. Never use your hand to clean out the
discharge chute.
To clear the chute:
• Shut the engine off !
• Wait 10 seconds to be sure the rotor blades have
stopped rotating.
• Always use a clean-out tool, not your hands
(Figure 24).

Preventing Freeze-up after Use

• Let the engine run for a few minutes to prevent
moving parts from freezing. Stop the engine, wait
for all moving parts to stop, and remove ice and
snow from the machine.
• Clean off any snow and ice from the base of the
chute.
• Rotate the discharge chute left and right to free it
from any ice buildup.
• With the ignition key in the Off position, pull the
recoil starter handle several times or connect the
electrical cord to a power source and the machine
and push the electric start button once (model 38569
12
Figure 24