I Optical Parts Disassemblies - Sanyo PLV-70 Service Manual

I Optical Parts Disassemblies

Before taking this procedure, remove Cabinet Top and Main Board following to the "Mechanical Disassemblies".
Disassembly requires a 2.0mm or 2.5mm hex wrench and a slot screwdriver.
Projection Lens removal
1
Remove Cabinet Front-Top following to the chapter "Mechanical
Disassemblies".
2
A
Loosen 2 screws with 2.5mm hex wrench.
3
B
Unhook 2 hooks on the both side of the lens and remove the
Projection Lens ass'y off.
B
A
A
Polarized Glass-In removal
1
Remove each hex screw and pull the Polarized Glass-In ass'y upward.
2
Remove a stopper and take the glass off upward.
B
Fig.1
Fig.2-
1
-13-
Part No. is printed on
upper side.
* Glass should be placed as the
printed marker comes to the
upper left corner.
Fig.1-
2
polarized glass
Phase Sheet
Stopper
Fig.2-
2