I Mechanical Disassemblies - Sanyo PLV-70 Service Manual

I Mechanical Disassemblies

Mechanical disassemble should be made following procedures in numerical order.
Following steps show the basic procedures, therefore unnecessary step may be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original otherwise it may cause loss of
performance and product safety.
1
Cabinet Top removal
1 A
Remove 5 screws , 2 screws
C, and then
take the Cabinet Top upward off.
Note: If you want to remove the Cabinet Front-Top only,
you do not need to remove screws
and Lens Front Cover.
2
Cabinet Front removal
1
Turn the Lens Front Cover counter-clockwise and to take
it off by pulling forward as shown in Fig.2-1.
2
Remove the Cabinet Front-Top, Lens Cover Holder and
Lens Cover upward off.
3 D
Remove 2 screws to take the Cabinet Front off.
4
Remove the RC Board and speakers on the Cabinet
Front.
B
, and loosen 2 screws
A B
. Remove 2 screws
Cabinet Front-Top
Lens Cover Holder
Lens
Front
Lens Cover
Cover
Fig.2
-1
-8-
A
A
A
C
C
Cabinet Front
A
A
B
B
Fig.1
D
D
Fig.2
-2