Hard Reset Of Eeprom Weather Center Memory; Adding Sensors - La Crosse Technology WS-7058U Instruction Manual

7. Use the + button to change the first digit to a 3 and press the SET
button to enter the normal mode. The Weather Center will enter
into normal operating mode. Do not press any buttons while the
Weather Center searches for transmisssion signals.
8. Follow Program Mode for set-up proceedures.
C. HARD RESET OF EEPROM WEATHER CENTER MEMORY
Note: This is to be used if there are problems with transmission, or if
the rainfall history bar graph needs to be cleared.
1. Remove the batteries and wait 30 seconds. (This will also reset the
Rainfall Quantity Totals).
2. Checking the polarity, install batteries.
3. During the brief 2 seconds that all LCD screens light up,
simultaneously press and hold the RAIN and + buttons.
"375" (the default rain multiplicator setting) will appear in LCD 1.
The "5" will be flashing.
If "375" does not appear, it will be necessary to set the manually
set the digits. Use the + button to change the digit, and the SET
button to select the digit to be changed.
4. Press the SET button two times. (The 3 should flash).
5. Hold the SET button down until the air pressure (in hPa) briefly
flashes in LCD 5. "LCD 5" will flash in LCD 2 for 15 seconds.
6. Do not press any buttons while the Weather Center searches for
transmission signals.
7. Follow Program Mode for set-up proceedures.
VII. ADDING MORE SENSORS (optional)
The WS-7058U can receive signals from up to three Sensors. The
Sensor model(s) that you choose will come with their own set of
instructions—follow those instructions for a complete guide to setting up.
Following are some brief instructions for the basic set-up of additional
sensors with the WS-7058U. Additional sensors can be purchased
through the same dealer as this Weather Center, or by contacting La
Crosse Technology directly (contact information can be found at the end
of this manual). A TX4U will monitor temperature and humidity (it is
the same model that comes with the WS-7058U), a TX3U will monitor
temperature only, and the TX3UP monitors temperature via a 10 foot
probe for use in pools, spas, etc. The TX3 units do not monitor humidity,
thus when they transmit their information to the Weather Center dashes
"- -" appear in the Humidity Display.
15