Dmx Mode; Set Dmx Adres - Beamz 150.568 Manual

MODE
S dAd
3CH
d-CH
4CH
t.CH
tA.S
SYS
dt.CH
s-tr
dtA.S
dr.CH
drA.S
d-SL
S AAd
S-Ir
rA.S r-AU
SLAu
r-St r001-r016
F000-F100
A000
SL.00-SL.32
ACt -
P000-P100
A023
C000-C100

DMX Mode

Set DMX adres

When selecting a starting DMX address, always consider the number of DMX channels. If you choose a starting
address that is too high, you could restrict the access to some of the product's channels. With 3Ch & 4CH, when in
4-channel DMX mode, it defines the highest configurable address 509.
Follow below to select the DMX starting address
Press <MODE> repeatedly until SYS,ACt,SLAv,or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>
Use <UP> or <DOWN> to select SdAd from the menu
Press <ENTER>
Use <UP> or <DOWN> to select the starting address.
Press <ENTER>
With 3CH and 4CH,follow below to setup
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS
Press <ENTER>
Use <UP> or <DOWN> to select d-CH from the menu
Press <ENTER>
Use <UP> or <DOWN> to select either the 3-channel mode (3CH) or the 4-channel mode (4CH)
Press <ENTER>
Description
DMX address setup 001-509
3CH DMX mode
4CH DMX mode
Manually select transmit frequency (for IR&Act use) t001-t016
Automatically select Receive frequency (for IR&Act use)
Manually select Transmit frequency (for DMX use) dt01-t16
Automatically select Transmit frequency (for DMX use)
Manually select receive frequency (for DMX use) dr.01-dr.16
Automatically select receive frequency (for DMX use)
Sensitivity low to high (SL.00-SL.32)
Reset software
IR Infrared remote control
Automatical select receive frequency (For IR&Act use)
Manually select receive frequency (For IR&Act use) r001-r016
Strobe speed (slow to fast )
Sensitivity low to high (SL.00-SL.32)
Run speed (slow to fast )
Brightness adjustment (dark to bright)
- 6 -