Table of Contents
Advertisement
For the receiving product(s).
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dR.CH appears on the display.
Press <ENTER>.
Use <UP> or <DOWN> to select the receiving signal (dr.01 - dr.16). The channel. number should match the
transmitting signal you chose in the prior steps.
Two products can be matched after finishing above steps.
Note: one transmitter can be used with multi receivers. Follow this actions and set one as transmitter, the others as
receivers, one transmitter can be used with multi receiver products.
IR/standalone mode auto Sync
Two or more products can be controlled with no external controllers or with the IRC. To automatically set up syncing
function for IR/standalone functionality, do the following.
For the transmitting product:
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until tA.s appears on the display.
Press <ENTER>.
The display should show t-AU.
For the receiving product(s).
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SLAv.
Press <ENTER>.
Press <UP> or <DOWN> until rA.S appears on the display.
Press <ENTER>.
The display should show r-AU.
Once the steps above are done, press and hold <AUTO> on the transmitter for approximately 20 seconds. The
signal LED of the receiver will flash to indicate sync is activated.
Note
cancel IR/standalone Auto Sync
Press the Auto button of the receiver until the indicator stops flash, which means Sync data is cancelled.
IR/standalone Auto Sync of multiple receivers and transmitters.
Repeat operations, match the next group after finishing match the first group. (Power off other fixtures when you
follow the actions and multiple groups can not be matched at the same time)
One transmitter to multiple receivers:
Follow the instructions and set one as transmitter, the others as receivers, set the auto Sync between one receiver
and one transmitter, and then power off the receiver, match another pair. Power on all the receivers after finishing,
multiple receivers can be controlled by one transmitter.
Note:
The distance of receiver and transmitter should be between 0.6 meter and 10 meter.
- 11 -
Advertisement
Table of Contents
