Table of Contents
Advertisement
DMX Mode Auto Sync
It offers wireless control of two or more products with a single DMX controller. To set syncing function for DMX
functionality automatically, do the following:
For the transmitting product.
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dtA.S appears on the display.
Press <ENTER>.
The display should show dt.AU.
For the receiving product(s).
Press <MODE> repeatedly until SYS, ACt, SLAv or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dRA.S appears on the display.
Press <ENTER>.
The display should show dR.AU.
Once the steps above are done, press and hold <AUTO> on the transmitter for about 20 seconds and the signal
LED of receiver will flash to indicate sync is activated.
Cancel Auto Sync.
Press the Auto button of the receiving product until the signal stops flash, which means the between the receiver
and transmitter is cancelled.
Auto Sync for receivers and transmitters:
Repeat operations, match the next group after finishing matching the first group. (Power off other fixtures when you
follow the actions and multiple groups can not be matched at the same time)
One transmitter to multiple receivers.
Follow the instructions and set one as transmitter, the others as receivers, set the auto Sync between one receiver
and one transmitter, and then power off the receiver, match another pair. Power on all the receivers after finishing,
multiple receivers can be controlled by one transmitter.
DMX Mode Manual Sync:
It can wireless control of two or more products with a single DMX controller. To manually set up the syncing function
for DMX functionality, do the following.
For the transmitting product.
Press <MODE> repeatedly until SYS,ACt,SLAv,or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dt.CH appears on the display.
PRESS <ENTER>.
Use <UP> or <DOWN> to select the transmitting signal (dt.01-dt.16).
- 10 -
Advertisement
Table of Contents
