Thank you for purchasing our company products. Please read these instructions carefully to enjoy optimum performance and a longer service life before you start to use. CONTENTS CONTENTS ............................. 2 Unpacking Inspections ..........................3 Unpacking instructions ........................3 ...
UNPACKING INSPECTIONS Unpacking instructions Please unpack the carton and check the goods carefully when you receive it , if discover packing damage, shortage or quality problem, please notify the shipper and reject the goods. Before using this product, please read the instructions carefully and keep it in a safe place for future reference.
Operation Instructions Power supply connecting Two sockets in the product, Power In and Power Out , the product can be supplied power by the power out. Maximum output power of the socket is 480W . POWER IN POWER OUT Maximum connecting machines are 22 units with the same model Control panel operation Use the four buttons MODE...
Act mode Standalone) Set the product in one of the standalone modes to control without connecting a DMX controller. Note: Never connect a product that is operating in any standalone mode to a DMX string connected to a DMX controller. Follow below actions to setup standalone mode Press <MODE>...
IR control It is fully compatible with the IRC (Infrared Remote Control),please follow below to setup. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display. Use <UP> or <DOWN> to select S-1r, Press <ENTER>, Begin using the IRC The functions of IRC: Automatic Mode Automatic Mode will enable you to run the automatic programs on the...
DMX Mode Auto Sync It offers wireless control of two or more products with a single DMX controller. To set syncing function for DMX functionality automatically, do the following: For the transmitting product. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display. Use <UP>...
For the receiving product(s). Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display. Use <UP> or <DOWN> to select SYS. Press <ENTER>. Press <UP> or <DOWN> until S-tr appears on the display. Press <ENTER>. Press <UP> or <DOWN> until dR.CH appears on the display. Press <ENTER>.
MAINTENANCE The unit should be cleaned periodically to ensure the optimum performance, the smudginess can decrease the life of light and the output of light is affected by the dust which can make the machine overheating. In general, make the maintenance at least two times a month.
Tel : 0031546589299 Fax : 0031546589298 The Netherlands 150.568 Product number: Product Description: Beamz, Wi-Par 198 LED RGB Batt. 2.4GHz DMX Regulatory Requirement: EN 60065 EN 55013: 2001/A2:2006 EN 55020: 2007/A11:2011 EN 61000-3-2/-3-3 EN 301489-1 V1.8.1 EN 301489-9 V1.4.1 EN 300422-1 V1.3.2 EN 300422-2 V1.2.2...