Troubleshooting - Empire Heating Systems SR-10T-3 Installation Instructions And Owner's Manual

1. Spark electrode does not produce spark.
a. Spark electrode broken - replace.
b. Ignitor wire may not be attached to spark electrode -
attach.
c. Ignitor wire damaged - replace.
d. Piezo ignitor defective - replace.
2. Spark electrode produces spark but pilot does not light.
a. No gas to heater - turn on gas.
b. PILOT position not properly aligned - turn gas control knob
to PILOT position and depress.
c. Pilot is blocked from spider web or dirt - clean pilot, see Page
14.
3. Pilot flame does not stay "ON" when control knob is
released.
a. Control knob in PILOT position not completely depressed or
held in long enough.
b. INTERLOCK latching device is operative - see "Lighting
Instructions," Page 12, Step 9.
c. Thermocouple not tightened into gas control - tighten
PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide.
INDEX PART NO. DESCRIPTION
NO.
1 13347 CASING SIDE ASSEMBLY - LEFT
2 SR-180 CASING BACK
3 R-2313 PIEZO IGNITOR
4 SR-008 CASING SIDE ASSEMBLY - RIGHT
5 SR-113 VALVE BRACKET
6 R-6563 GAS VALVE -SIT
7 12438 TUBING - GAS VALVE TO BURNER
TUBING - INLET REGULATOR TO GAS
8 12437
VALVE
9 10753 INLET REGULATOR BRACKET
10 R-5097 INLET REGULATOR - NAT
10 R-5098 INLET REGULATOR - LPG
11 SR-158 TUBING - GAS VALVE TO PILOT
12 R-2314 ORIFICE HOLDER
13 R-2317 MAIN BURNER ORIFICE - NAT
13 R-2476 MAIN BURNER ORIFICE - LPG
14 R-2331 BURNER
PILOT ASSEMBLY (LPG ONLY) (IN-
15 R-6308
CLUDES ITEMS 16 & 17)
PILOT ASSEMBLY (NAT ONLY) (IN-
15 R-6307
CLUDES ITEMS 16 & 17)
16 R-6310 PILOT THERMOCOUPLE
17 R-6309 SPARK IGNITOR
Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, Illinois 62222-0529
Page 16

TROUBLESHOOTING

4. Main burner does not ignite.
5. Heater keeps shutting "OFF" during normal operation.
PARTS LIST
SR-10T
INDEX
NS - NOT SHOWN
thermocouple.
d. Pilot flame not surrounding thermocouple - clean pilot, see
Page 14.
e. Inlet gas pressure too low, contact gas supplier.
f. Thermocouple defective - replace.
g. Gas control defective - replace.
a. Main burner orifice is blocked - clean, see "Main Burner Flame
Characteristics," Page 13. Attention: The number stamped
on the main burner orifice is a millimeter diameter.
b. Inlet gas pressure too low, contact gas supplier.
a. Pilot is blocked - clean pilot, see Page 14.
b. Inlet gas pressure too low, contact gas supplier
PART NO. DESCRIPTION
NO.
18 SR-179 PILOT BRACKET (NAT)
18 SR-032 PILOT BRACKET (LPG)
19 SR-153 ORIFICE SHIELD
20 R-2305 CHROME GRILL
21 SR-134 CASING LOUVER (2 REQUIRED)
22 SR-129 REFLECTOR ASSEMBLY
23 SR-135 HEAT SHIELD
24 R-1992 BULB CLIP
25 SRS-10 OPTIONAL FLOOR STAND KIT
NS R-2390 IGNITOR WIRE
NS SR-216 HARDWARE PACKAGE
16941-8-0314