Troubleshooting; How To Order Repair Parts; Sr-10T Parts List - Empire Heating Systems SR-10T-3 Installation Instructions And Owner's Manual

1. spark electrode does not produce spark.
a. Spark electrode broken - replace.
b. Ignitor wire may not be attached to spark electrode -
attach.
c. Ignitor wire damaged - replace.
d. Piezo ignitor defective - replace.
2. spark electrode produces spark but pilot does not light.
a. No gas to heater - turn on gas.
b. PILOT position not properly aligned - turn gas control knob
to PILOT position and depress.
c. Pilot is blocked from spider web or dirt - clean pilot, see
Page 14.
3. Pilot flame does not stay "on" when control knob is
released.
a. Control knob in PILOT position not completely depressed
or held in long enough.
b. INTERLOCK latching device is operative - see "Lighting
Instructions," Page 12, Step 9.
Parts can be ordered only through your service person or dealer. For best results, the service person or dealer should order parts through
the distributor. Parts can be shipped directly to the service person/dealer.
All parts listed in the Parts List have a Part Number. When ordering parts, first obtain the Model Number from the name plate on your
equipment. Then determine the Part Number (not the Index Number) and the Description of each part from the following appropriate
illustration and list. Be sure to give all this information.
Unvented Heater Model Number
Unvented Heater Serial Number
Type of Gas (Propane or Natural)
Do not order bolts, screws, washers or nuts. They are standard hardware items and can be purchased at any local hardware store.
Shipments contingent upon strikes, fires and all causes beyond our control.
PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide.
INDeX PART
NUMBeR NUMBeR
1 13347
2 SR-180
3 R-2313
4 SR-008
5 SR-113
6 R-6563
7 12438
8 12437
9 10753
10 R-5097
10 R-5098
11 SR-158
12 R-2314
13 R-2317
13 R-2476
14 R-2331
15 R-6308
empire Comfort Systems, Inc. Nine eighteen Freeburg Ave. Belleville, Illinois 62222-0529
Page 16

TROUBLEShOOTING

hOW TO ORDER REPAIR PARTS

PARTS LIST
DeSCRIPTION
CASING SIDe ASSeMBLY - LeFT
CASING BACK
PIEZO IGNITOR
CASING SIDe ASSeMBLY - RIGHT
VALVE BRACKET
GAS VALVe -SIT
TUBING - GAS VALVe TO BURNeR
TUBING - INLeT ReGULATOR TO GAS
VALVe
INLET REGULATOR BRACKET
INLeT ReGULATOR - NAT
INLeT ReGULATOR - LPG
TUBING - GAS VALVe TO PILOT
ORIFICe HOLDeR
MAIN BURNeR ORIFICe - NAT
MAIN BURNeR ORIFICe - LPG
BURNeR
PILOT ASSEMBLY (LPG ONLY)
(INCLUDES ITEMS 16 & 17)
c. Thermocouple not tightened into gas control - tighten
thermocouple.
d. Pilot flame not surrounding thermocouple - clean pilot, see
Page 14.
e. Inlet gas pressure too low, contact gas supplier.
f. Thermocouple defective - replace.
g. Gas control defective - replace.
4. Main burner does not ignite.
a. Main burner orifice is blocked - clean, see "Main Burner Flame
Characteristics," Page 13. Attention: The number stamped
on the main burner orifice is a millimeter diameter.
b. Inlet gas pressure too low, contact gas supplier.
5. heater keeps shutting "oFF" during normal operation.
a. Pilot is blocked - clean pilot, see Page 14.
b. Inlet gas pressure too low, contact gas supplier
Part Description
Part Number
SR-10T
INDeX PART
NUMBeR NUMBeR
15 R-6307
16 R-6310
17 R-6309
18 SR-179
18 SR-032
19 SR-153
20 R-2305
21 SR-134
22 SR-129
23 SR-135
24 R-1992
25 SRS-10
NS R-2390
NS SR-216
DeSCRIPTION
PILOT ASSEMBLY (NAT ONLY)
(INCLUDES ITEMS 16 & 17)
PILOT THeRMOCOUPLe
SPARK IGNITOR
PILOT BRACKET (NAT)
PILOT BRACKET (LPG)
ORIFICe SHIeLD
CHROMe GRILL
CASING LOUVER (2 REQUIRED)
ReFLeCTOR ASSeMBLY
HeAT SHIeLD
BULB CLIP
OPTIONAL FLOOR STAND KIT
IGNITOR WIRe
HARDWARE PACKAGE
16941-6-1009