Installation And Safety Considerations; Setting Up The Switch As A Standalone Unit - IBM SAN06B-R Installation, Service And User Manual

v An accessory kit that contains the following items:

Installation and safety considerations

Use this section to prepare your site for a safe and successful installation.
Ensure that two dedicated electrical branch circuits with the following
characteristics are available:
v Primary ac input 100-240 V ac, 2.0A, 47 to 63 Hz (the switch autosenses input
v Correctly wired primary outlets, with circuit protected by a circuit breaker and
v Adequate supply circuit, line fusing, and wire size, as specified by the electrical
v Located close to the product, and easily accessible
Note: To maximize fault tolerance, connect each power cord to a separate power
For power supply information, see "Power supply" on page 38.
To ensure adequate cooling, install the switch with the nonport side, which
contains the air intake vents, facing a cool-air aisle.
Verify that the ambient air temperature does not exceed 40° C (104° F) and that the
ambient humidity remains between 20% and 85% while the switch is operating.

Setting up the switch as a standalone unit

To install the switch as a standalone unit, use the following procedure:
1. Unpack the switch and verify that all items listed in "Items included with the
8
SAN06B-R Installation, Service, and User Guide
– SAN06B-R Quick Start Guide
– SAN06B-R Installation, Service, and User Guide (this document).
– IBM documentation CD
– Four rubber mounting feet, required for setting up the product as a
stand-alone unit
– Two grounded 6 ft. (1.8 m.) country-specific power cables
– One RJ-45 serial cable with an RJ-45 to DB9 adaptor
– Paperpack of optional features license and key activation information (if
ordered)
Attention: Retain this paperpack in a safe place. The transaction keys in
the paperpack are required for activation of optional features on the switch.
Once a feature is activated, its activation key is associated with a specific
product WWN and serial number.
Attention: Read the "Safety and environmental notices" on page xiii
before attempting any installation, maintenance, or service procedures.
voltage)
grounded in accordance with local electrical codes
rating on the chassis nameplate
source.
switch" on page 7 are present and undamaged.