Table of Contents
Advertisement
Front Panel . . . Continued
6.
OLED Display
Indicates the currently selected channel's network name and its gain value and if
either Front Panel Lockout
to display local and network configuration settings when in INFO mode. See below.
7.
Local Control Buttons:
• INFO – Press to show device and network information on the OLED display [button will
flash orange when Info mode is engaged]. Pressing again cycles through following unit
settings:
Unit IP addresses (primary)
Unit IP addresses (secondary)
Unit MAC addresses (primary)
Unit MAC addresses (secondary)
Firmware Version for the unit
Device name
• +48V – Switches phantom power on for selected channel.
• 2.4 kΩ – Selects low input impedance for selected channel.
•
– Switches on high-pass filter for selected channel.
• -20 dB – Switches input pad in for selected channel.
• Ø – Inverts polarity of signal on selected channel.
8.
Encoder
The detented encoder is used as the gain control for the selected mic channel.
Note: When renaming a device, the name will appear on a single line on the OLED display. To seperate the
name over two lines like the OLED example above, add in a double-dash '--'. In the example above, this would
be written as 'mp8r--b-vox-1'.
6
7
or Gain Compensation
9
ON
8
is active. Also changes
Advertisement
Table of Contents
