Setup By Connecting The Computer And Projector With A Usb Cable; Saving Settings To A Computer - Epson EB-536Wi User Manual

Performing Batch Setup for Multiple Projectors
c
While holding down the [Menu] button on the remote control or
the control panel, connect the power cord to the projector.
The status indicator and the power indicator turn blue, and the lamp
indicator and the temperature indicator turn orange.
When all of the projector's indicators turn on, release the [Menu]
button. The indicators turn on for approximately 75 seconds.
When all of the indicators start flashing, the settings are being
written.
Caution
 Do not disconnect the power cord from the projector while the
settings are being written. If the power cord is disconnected, the
projector may not start correctly.
 Do not disconnect the USB storage device from the projector while the
settings are being written. If the USB storage device is disconnected,
the projector may not start correctly.
When writing completes normally, the projector turns off, and only the
power indicator is lit blue.
When the projector turns off, disconnect the USB storage device.
Setup by Connecting the Computer and Projector
with a USB Cable
a
The following operating systems support the batch setup function.
 Windows Vista and later
 Mac OS X 10.5.3 and later

Saving Settings to a Computer

a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the computer's USB port to the projector's USB-B port
with a USB cable.
138