Setup By Connecting The Computer And Projector With A Usb Cable; Saving Settings To A Computer - Epson EB-810E Installation Manual

Setting the Projector
c
While holding down the [Menu] button on the remote control or the control panel, connect
the power cord to the projector
The Power indicator and the Status indicator turn blue, and the Laser indicator and the Temp indicator
turn orange.
When all of the projector's indicators turn on, release the [Menu] button. The indicators turn on for
approximately 75 seconds.
When all of the indicators start flashing, the settings are being written.
Caution
•
Do not disconnect the power cord from the projector while the settings are being written. If the power
cord is disconnected, the projector may not start correctly.
•
Do not disconnect the USB flash drive from the projector while the settings are being written. If the
USB flash drive is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off, and only the Power indicator is lit blue.
When the power turns off, remove the USB flash drive.

Setup by Connecting the Computer and Projector with a USB Cable

c
The following operating systems support the batch setup function.
•
Windows10 and later
•
macOS 10.13.x and later

Saving settings to a computer

a
Disconnect the power cord from the projector, and check that all of the projector's
indicators have turned off
b
Connect the computer's USB port to the projector's USB-B port with a USB cable
64