Reading Error Notification Mail; Management Using Snmp - Epson EB-536Wi User Manual

Monitoring and Controlling
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
Network - Mail - Mail Notification
s
a
 Up to three notification destinations (addresses) can be registered,
and notification messages can be sent to all three destinations at
once.
 If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
 Controlling is possible if Standby Mode is set to Communication
On, even if the projector is in standby state (when the power is
off).
s ECO - Standby Mode

Reading Error Notification Mail

When the Mail Notification function is set to On and a problem or warning
occurs in the projector, the following email will be sent.
Sender: Email Address 1
Email title: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has occurred
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message
contents are listed below.
 Internal error
 Fan related error
 Sensor error
p.131
p.133
 Lamp timer failure
 Lamp out
 Internal temperature error
 High-speed cooling in progress
 Lamp replacement notification
 No-signal
No Signal is input to the projector. Check the connection status or check
that the power for the signal source is turned on.
 Auto Iris Error
 Power Err. (Ballast)
See the following to deal with problems or warnings.
"Reading the Indicators"
s

Management Using SNMP

By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
Network - Others - SNMP
s
p.143
p.132
105