Page 1
RM20 Rauchwarnmelder mit Hitzewarnfunktion Bedienungs-, Installations- und Wartungsanleitung Rauchwarnmelder mit Hitzewarnfunktion User manual Smoke alarm device with heat alarm function Consignes d‘utilisation et d‘installation Détecteur d‘alarme de fumée avec signal d‘avertissement de chaleur Gebruikers- en installatiehandleiding Rookmelder met hittesensor Istruzioni per l’uso e l‘installazione Rilevatore di fumo con funzione di relevamento del calore –...
Page 2
RM20 Smoke alarm device with heat alarm funktion User manual Smoke alarm device with heat alarm function...
CoNTENTS Thank You Inspection and Maintenance Start-Up Equipment life Function Possible Causes of a Fault Alarm Choosing a Location Warranty Battery Error Message Intended Use Assembly Adhesive Mounting CE Conformity Mounting by Drilling Disclaimer General Safety Guidelines Limitation of Liability...
THANK YoU ! We are pleased that you have chosen This household smoke alarm has to buy our product and thank you for been developed and manufactured placing your trust in our company! with the utmost care, so that you can You have made a good decision.
CoMMISSIoNING • Heat alarm tone: single beep, once a second First of all, remove any activation • Smoke alarm tone: double beep, safeguards (e.g. a cotter pin) and once a second make sure that the activation safe- guard does not get into the device! Then press the device’s activation CHooSING A LoCATIoN button (Fig. 1, I.) which is shown in Fig. 2...
As a minimum requirement in the temperature in the room. smoke alarms should be installed in In the event of fire, a loud alarm tone all bedrooms, children’s rooms and sounds as a warning. If you are sure corridors that function as escape that there is no genuine need to evac- routes, only in the middle of the uate the building, you can temporar- ceiling (no wall mounting).
approx. 10 seconds. Then you can tones, the unit will continue to function for a maximum of 60 days place the device on the magnet and needs to be replaced before this carrying frame (Fig. 1, III.). The 60-day period has expired! adhesive bond will reach its ultimate strength after approx. 72 hours.
screw too tightly as this could The unit is a closed system. Any form deform/distort the magnetic mount. of tampering with the unit’s interior will result in the loss of any existing warranty and make it impossible for the unit to be implemented in accordance with its intended use. Never open the unit as this can place you at risk of injury.
IMPoRTANT NoTE: The unit gives an early warning if its energy capacity is low or if the detec- The smoke alarm is only able to tion optics have become so full of provide a warning, and potentially imperfections that readjustment is save lives, if it is located in its intend- no longer possible. This gives you ed installation position, is free from...
place and that the smoke inlet ribs • An alarm can only be activated by (II) are completely free from any cigarette smoke if the smoke enters foreign bodies. Useful information on the unit directly or in very high regular maintenance and choosing an opti- concentrations. The unit should be mum location for installation can be protected from the abovemen-...
• The detection of fire or smoke in private households • ABUS assumes no liability for defects or damage that has been caused by external influences (e.g. transport, • The smoke alarm has a heat alarm function. It is not, however, a “heat external forces, misuse), improper use, normal wear and tear or non- detector” under the terms of EN 54-5.
BY LEGISLATIoN, oR, IN THE EVENT oF THE ABUS, AUGUST BREMICKER SöHNE KG (“ABUS”) RESTRICTED WARRANTY NoT BEING APPLICABLE, ASSUMES No FURTHER EXPLICIT oR IMPLICIT ABUS’S SCoPE oF LIABILITY IS RESTRICTED To THE LIABILITY oF ANY KIND BEYoND THE APPLICABLE PURCHASE PRICE OF THE PRODUCT. LEGAL PROVISIONS. THIS ALSO EXTENDS TO ANY LIABILITY RELATING To MARKETABILITY AND/oR...
Need help?
Do you have a question about the RM20 and is the answer not in the manual?
Questions and answers