Mitsubishi Electric MR-G57N Operating Instructions Manual page 26

What to do when...
Electric power goes out
Refrain from frequently opening and closing the
refrigerator doors, and avoid storing additional items.
Setting for modes other than temperature may change.
Please check. (Child Lock, Energy-Saving, Fast Cooling, etc.)
Transporting the unit
Discard the water and ice in the water
tank and the ice tray.
Wear the protector such as work-gloves.
Remove the leg cover and lift up the
adjustable support.
Pull out the power supply plug.
Place towels beneath the exhaust port and
at the corner beneath the back side of the
refrigerator and then place a container or a
tray about 3cm high to collect water.
*Towels must be placed to prevent water
leakage and possible damage to the floor.
Slowly tilt by about 30 degrees towards the rear and
drain water collected in the evaporating dish from the
exhaust port located at the bottom of the rear side.
(The evaporating dish is not visible from outside.)
*As it is heavy, the work must
be performed by two people.
*Small children or people
not confident about their
physical strength should not
try to participate and should ask
a transportation company to do the work.
Gently transport the unit with 2 or more people,
gripping the hand-holds on the lower-front interior
and the upper-rear of
the unit.
Do not lay the unit on its side
(doing so can cause malfunction
of the compressor).
Warning
It uses flammable refrigerant, do not damage the refrigerant
circuit. If the gas leaks, ignition or explosion may be caused.
To move the refrigerator or to change the direction
Lift adjustable supports
Move it in forward and backward directions
*Dragging it in directions other than the longitudinal forward
and backward directions may cause damage to the floor.
Make sure to place a cloth for floor
protection underneath the caster and
rear support before changing directions.
26
23
page
Front Lower interior Upper part of back side
7
page
If all indicators blink 3 times every 30 to 60
seconds even though no button has been
pressed.
Or, if the compartment display and
temperature control display on the control
panel blink in turn repeatedly.
(Demonstration operation mode)
The refrigerator suspends its cooling function during this mode.
Please contact the retail store at which you purchased it or reset
the demonstration operation by the following resetting method.
How to cancel demonstration operation
Keep the refrigerator door open.
Press
simultaneously and hold for about 5 seconds.
(Until a "beep" sound is heard)
If mark is blinking rapidly
(about 5 times per second)
Or if the alarm cannot be turned off.
Contact the retail store at which you purchased it
or the consumer service office.
Pressing "ICE SELECT" and holding for about 5
seconds will stop the alarm if it keeps sounding.
However, as it is necessary to perform inspection,
please contact the retail store at which you purchased
it or a Customer Service representative.
The unit will not be used for a long period of time
Clean the automatic ice maker.
After removing the power plug from
the outlet, clean the interior of the unit.
Leave the doors open for 2 to 3 days to
sufficiently dry the interior of the unit.
*Failure to sufficiently dry the interior of the unit can cause molding, odours,
and refrigerant (gas) leakage due to corrosion of the condenser.
, and
31
page
23
page