Side Panel - Panasonic WX-CC411 Operating Instructions Manual

External control output [DEVICE]
This external control output is used for alerts.
Using this unit's settings, this connector is controlled in
response to the reception of alert signals from the All-In-
One Headsets or Belt Packs and to the signals from the
alert input.
Alert input [ALERT]
This external input connector is used for alerts. It is
connected to a sensor or other external device.
Serial port [RS-232C]
This port is for controlling the system from a personal
computer.
For details, contact the store where you purchased this
unit.
Video output [VIDEO OUT]
This NTSC type of composite connector is for outputting
camera images.
For details, contact the store where you purchased this
unit.
Network port [10BASE-T/100BASE-TX]
This is connected to a 10BASE-T or 100BASE-TX
network, and it connects the Network Camera with the
Center Module.

Side panel

Reset button
Press this button using a fine-tipped object when this unit
is not operating properly to restart this unit.
SD card slot
This is where an SD card is inserted.
SD card access LED
This indicates the status of the SD card access. While the
SD card is being accessed, it blinks in green.
Important
While the SD card access LED is blinking, do not
eject the SD card, disconnect the power plug or press
the reset button. Performing any of these actions may
destroy the data on the card.
13