Efi Diagnostic Mode - Polaris 2007 Sportsman 500 EF Service Manual

Screen 6: Miles/Kilometers:
The display in the trip meter and odometer can be changed to
display either kilometers or miles. The current display mode
will be shown as "KM" or "MP". To change, hold in the mode
button until the letters flash, then press and release the button
once. When the display stops flashing, the mode has been set.
MP = Miles
KM = Kilometers

EFI Diagnostic Mode

NOTE: The EFI diagnostic mode is intended to
quickly view fault codes stored in the EFI module.
Polaris dealers are equipped with the proper
diagnostic tools to further diagnose the blink codes.
To recall blink codes (fail codes) from the ECM:
1. Verify the ATV key switch is off and the transmission is in
park.
2. Turn the key switch ON and OFF 3 times within 5 seconds
and leave the key switch in the ON position on the third
turn.
ON
3. The word "Wait" will appear, the ECM is now searching
for blink codes. READ AND RECORD THE NUMBER
OF FLASHES OF THE 'MIL' (Check Engine) LIGHT.
Codes '12' and '61' indicate the beginning and end of the
check sequence.
NOTE: The 'check engine' icon (mil) will flash the
codes during this mode.
sequences.
4. The word "End" will display after all of the codes have been
displayed.
ELECTRICAL
Record the flash
10
10.17