Special Efi Diagnostic Mode - Polaris Sportsman 700 EFI 2006 Owner's Manual For Maintenance And Safety

Instrument Cluster
Rider Information Center

Special EFI Diagnostic Mode

The EFI diagnostic mode is for informational purposes only. Please
see your Polaris dealer for all major repairs. To download blink codes
(failure codes) from the EFI module:
1. Place the transmission in PARK, turn the engine off and turn the
key switch to the ON position.
2. Turn the key switch off and on three times in less than five
seconds, then leave the switch on. Any blink code numbers stored
in the EFI module will display, one at a time, in the alphanumeric
display. The number "61" and the word "END" will display after
all codes have been transmitted.
Blink Failure Description
Code
- No RPM Signal
21 Loss of Synchronization
45 Barometric Pressure Sensor:
Circuit Low Input
46 Barometric Pressure Sensor:
Circuit High Input
22 TPS: Open or Short Circuit to
Ground
22 TPS: Short Circuit to Battery
23 RAM Error: Defective ECU
42 Engine Temp Sensor Circuit:
Short to Ground
42 Engine Temp Sensor Circuit:
Open or Short to Battery
51 Injector 1: Open Load
51 Injector 1: Short Circuit to Ground
51 Injector 1: Short Circuit to Battery
52 Injector 2: Open Load
52 Injector 2: Short Circuit to Ground
52 Injector 2: Short Circuit to Battery
FEATURES AND CONTROLS
Blink Failure Description
Code
54 Engine Temp Lamp: Open Load
54 Engine Temp Lamp: Short Circuit
to Ground
54 Engine Temp Lamp: Short Circuit
to Battery
55 Diag Lamp: Open Load
55 Diag Lamp: Short Circuit to
Ground
55 Diag Lamp: Short Circuit to
Battery
56 Pump Relay: Open Load
56 Pump Relay: Short Circuit to
Ground
56 Pump Relay: Short Circuit to
Battery
41 Intake Air Temp Sensor: Open or
Short Circuit to +Sensor Voltage
41 Intake Air Temp Sensor: Short
Circuit to Ground
61 END
45