Pressure Switch; Door Spring; Hinge Assembly - Electrolux FMB330RGB0 Service Manual

Mounting screws
Front frame rail
Water Valve

Pressure Switch

1. Disconnect power to dishwasher.
2. Remove as much water as possible from sump.
3. Remove toe kick and outer door panel.
4. Remove unit from under counter top far enough to
access back of pressure switch.
5. Removing junction box could give you access to
the pressure switch.
caution
The following repairs will require pulling the
dishwasher either part way or all the way from under
the counter top. When removing the product from
under the counter, extreme care must be taken to
protect the product and the floor from damage.
Always use protection under the feet and legs when
pulling unit out. When reinstalling make sure product
is leveled and secured.

Door Spring

1. Loosen dishwasher and pull forward to access door
spring.
2. Pull pin out of side frame to release top of spring.
3. Replace spring adjust as needed by installing pin
into proper hole in frame. Apply grease on both
ends of the spring after making finial adjustment.
4. Reinstall making sure unit is level and secure.
Junction box
Mounting pin
Frame
14
6. With pliers, compress mount on back side of
switch and pull switch from frame. See figure
below
7. Disconnect the three wires from the pressure
switch. Terminals have locks, press down on lock
to remove terminal.
8. Remove pressure
hose from switch by
pushing it from the
switch.
9. Complete repair in
reverse order.

Hinge Assembly

1. Disconnect power to dishwasher.
2. Loosen dishwasher and pull forward to access door
spring.
3. Pull pin out of side frame to release top of spring.
4. Remove outer door panel.
5. Remove screws and nuts holding inner door panel
to hinges, close and latch inner door panel.
6. Remove locking clip from both hinge pins and slide
hinge assemble from product.
7. Reassemble in reverse order making sure lubricant
is used on both ends of springs.
8. Adjust springs as needed before installing under
counter.
9. Reinstall making sure unit is level and secure.
Locking Clip
Mounting Screws
Hinge pins