DeWalt D25961 Instruction Manual page 10

FIG. 4A
B
F
Horizontal applications (Fig. 4A):
Proper hand position requires one hand on the side handle (F) and
the other hand on the main handle (B).
Vertical applications (Fig. 4B):
Proper hand position requires both hands on the main handle (B).
Switching On and Off (Fig. 1)
To turn the tool on, set the on/off switch (A) to position 1. To turn the
tool off, set the on/off switch (A) to position 0.
FIG. 4B
B
Demolition, Chasing and Channelling
(Fig. 1, 4)
WARNING: Ensure that the cutting edge does not show
discoloration caused by too much pressure. This may impair the
hardness of the accessory.
Various types of chisels are available as an option.
1. Select the appropriate chisel. Clean and grease its shank.
2. Insert the chisel and check whether it is properly locked.
3. Fit and adjust the side handle (F) and ensure side handle is
secure and does not rotate.
4. Hold the tool at both handles (B, F) and switch on. The tool now
runs in continuous operation.
5. Always switch off the tool when work is finished and before
unplugging.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making
any adjustments or removing/installing attachments or
accessories.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with dry air at
least once a week. Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye
protection and proper NIOSH/OSHA/MSHA respiratory protection
when performing this.
8