Getting Started; Installing The Battery - Kyocera QCP 2035 User Manual

1 G S
ETTING TARTED

Installing the battery

1. Hold the phone face
down in your palm with
the antenna pointing
down. Place your thumb
on the ridges of the
battery door. Push down
with your thumb and
slide the door away from you until it
stops (about 1/2 inch or 1.27
centimeters).
2.
Move your thumb to the
side of the phone, then
slide the door off the
phone.
3. Place the battery with
the metal contacts
facing down and
towards the bottom of
the phone.
User's Guide for the QCP 2035 Phone
4. Lay the keypad
flat inside the
faceplate. Align
the slots in the
phone to the
posts on the
faceplate, and close until they are
latched together.
5. Place the phone
face down on a flat
surface. Align the
battery door to the grooves on the
side of the phone. Slide the battery
door on while pressing down firmly,
ensuring that the battery door clicks
into place. Check and repeat if the
battery door is not aligned. Do not
force.
Note— Before using your phone, fully
charge the battery (see page 7).
1