Shoretel System Settings - Allocating Ports For; Switch Settings - Trunk Group - ShoreTel IP8000 Application Note

Switch Settings - Allocating Ports for SIP Trunks
The final general settings to configure are the ShoreGear
switch settings. These changes are modified by selecting
"Administration" then "Switches" in ShoreWare Director
(Figure 5).
Figure 5 – Administration/Switches
This action brings up the "Switches" screen. From the
"Switches" screen simply select the name of the switch to
configure. The "Edit ShoreGear ...Switch" screen will be
displayed. Within the "Edit ShoreGear ...Switch" screen
select the desired number of SIP trunks from the ports
available (Figure 6).
Figure 6 – ShoreGear Switch Setting
Each Check box designated as a SIP trunk enables support
for 5 individual trunks.
ShoreTel System Settings - Trunk Group
ShoreTel Trunk Groups support both Dynamic and Static SIP
end point Individual Trunks.
Note: A ShoreGear switch can only support one Trunk
Group with Dynamic IP addressing.
The settings for Trunk Groups are changed by selecting
"Administration" then "Trunks" followed by "Trunk Groups"
within ShoreWare Director (Figure 7).
Figure 7 – Administration /Trunk Groups
IP8000 Conference Phone Application Note—Page 4