Configuration Overview; Shoretel Configuration; Shoretel System Settings - General; Call Control Settings - ShoreTel IP8000 Application Note

Configuration Overview

The following steps are required to configure the IP8000
conference phone to work with the ShoreTel system:
1. Configure General ShoreTel system settings
a. Call Control Options, Site and Switch settings
b. Setup Trunk Groups
c. Setup Individual Trunks and User Groups
d. Setup Off system extensions
2. Configure the IP8000 to function with the ShoreTel
system

ShoreTel Configuration

This section describes the ShoreTel system configuration to
support the IP8000.The section is divided into general
system settings and trunk configurations (both group and
individual) needed to support the conference phone.

ShoreTel System Settings - General

The first settings to address within the ShoreTel system are
the general system settings. These configurations include
the call control, the site and the switch settings. If these
items have already been configured on the system, skip this
section and go on to the "ShoreTel System Settings – Trunk
Groups" section below.
The "Call Control / Options" screen will then appear (Figure 2).

Call Control Settings

The Call Control Options within ShoreWare Director may
need to be reconfigured. To configure these settings for the
ShoreTel system, log into ShoreWare Director and select
Administration, Call Control and then Options (Figure 1).
Figure 1 – Administration Call Control/Options
Figure 2 – Call Control/Options
IP8000 Conference Phone Application Note—Page 2