Installation Options; Outside Pole Mount (Best Option) - Wilson Electronics 460001 Installation Instructions Manual

8. Connect the DT4G to a surge protected
AC power strip with at least a 1000
Joule rating. If your DT4G is working
correctly, the lights will be green.
If the lights are orange or red, see
the "Troubleshooting" section on
page 10.
NOTE:
pane windows with coatings will
weaken the cellular signals as
they pass through because of a
manufacturing. If you have dual-
coatings, we recommend one
of the other mounting options if
your performance is not to your
satisfaction.
6
Need help? www.WilsonElectronics.com

Installation Options

Outside Pole Mount Option
(Best Option)
1. Select a location on the roof where the
Outside Antenna can be mounted on
a pole maintaining at least 20 feet of
vertical or horizontal separation from the
inside Desktop Antenna.
Place the desktop signal
antenna directly beneath the
placement of the Outside
Antenna location
At least 20 feet of vertical
or horizontal separation
from the desktop antenna
is needed
2. Find an existing pole or obtain a
pole of 1 to 2 inches in diameter.
Mounting hardware to attach the pole
to the roof can be purchased from a
hardware store or you can purchase
a Wilson's pole mount accessory kit,
part #901117. Install the pole in the
desired location.
3. Using the hardware in Packet A, slide
both brackets onto U-bolt. Tighten nut
& washers set onto U-bolt.
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST