Dt4G And Desktop Antenna Placement - Wilson Electronics 460001 Installation Instructions Manual

3. Keep the DT4G and the Desktop
Antenna at least 18 inches away
from each other with the Wilson logo
on the Desktop Antenna facing away
from the DT4G.
Minimum separation
4. Do not face the Outside Antenna and
the Desktop Antenna toward each
other. This can cause the DT4G
to show red lights and shut down,
preventing oscillation or feedback
(see troubleshooting on pg. 13).
In other words, the Wilson logos
on the Outside Antenna and the
Desktop Antenna should always be
facing away from each other.
5. If you do not know how to mount
hardware or run coax cable through
www.wilsonelectronics.com/installers
electrician. You can also try the Inside
Window Mount option (pg.5), which
Recommended: Lightning Surge
Protector (Sold Separately, part #859992)
We recommend you install the Lightning
Surge Protector (LSP) close to the
DT4G. Attach the cable from the Outside
Antenna to the surge protector and
ground the surge protector. The LSP is
sold separately.
Need help?
of 18 inches
DO NOT
face the Outside Antenna and
the Desktop Antenna toward
each other
Ground
Wire
www.WilsonElectronics.com
DT4G and Desktop Antenna
Placement
1. Select a location for the DT4G that
is away from excessive heat, direct
sunlight, and moisture and has proper
ventilation. Recommended locations
include on a shelf, in a closet, on a
desk or behind it. Be sure the location
is near a power outlet. To ensure
proper ventilation, keep other objects
at least six (6) inches away.
2. Place the DT4G on a desk, table or
other solid surface where you have
routed the cable from the Outside
Antenna.
3. Attach the coax cable from the
Outside Antenna to the DT4G at the
connector labeled "Outside Antenna."
4. Attach the Inside Antenna to the
connector labeled "Inside Antenna."
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
9