Sag; Set-Up Of Rebound Fox Nude/Ctd Shock; Set-Up Of Rebound Fox Nude Or Fox Ctd Shock - Scott 2015 Spark Series Owner's Manual

SAG

The SAG should be 10mm on the shock piston.
To check the adjustment, please follow the below instructions:
1. Sit on the bike, put your feet on the pedals
2. Put your feet back on the ground and stand over the bike without bouncing the
bike during this action
3. Check if the o-ring (S9) on the shock piston (S8) has a distance of 10mm to the
main dust wiper/seal between shock housing and piston.
- if the distance between the o-ring and the main dust wiper/seal is 10mm, the air
pressure is correct for your weight
- if the distance between the o-ring and the main dust wiper/seal is less than 10mm,
the air pressure of the air chamber is too high and should be carefully reduced by
using the bleed knob of the shock pump until the distance is 10mm.
- if the distance between the main dust wiper/seal is greater than 10mm, the air
pressure of the air chamber is too low and should be increased by using the shock
pump until the distance is 10mm.

SET-UP OF REBOUND FOX NUDE OR FOX CTD SHOCK

"Rebound" describes the speed the shock comes back to its original length after
absorbing an obstacle.
By using the rebound adjuster knob (S4) you can adjust the rebound step by step.
16
SPARK | BIKE OWNER'S MANUAL 2015
Please refer to the following instruction:
Ride your bike off a pavement (remain in the saddle) and check how many times it
bounces.
- If it bounces 1-2 times, the set up is good.
- If it bounces more than 3 times the rebound is too fast. Turn the knob 1-2 "clicks"
clockwise
- If it does not bounce the rebound is too slow. Turn the knob 1-2 "clicks" counter
clockwise.
IMPORTANT!
Note that you have to mount the FOX Nude Shock always as shown below.
Mounting the rear shock in a different position can cause severe damage to the
frame, the linkage levers and the rear shock.
Same for the FOX Float CTD and X-Fusion E1 shock on some of the Spark models.
IMPORTANT!
After a dismantlement of the rear shock, both fixing bolts should be tightened with a
tightening torque of 10Nm/88in-lbs.
If this is not done correctly the rear shock can be damaged.
Please only use SCOTT shock bolts and follow the assembly instructions
shown below:
Please only use the matching adjustment
shims as their shape is designed specifically
to fit with the countersunk bolts.
BIKE OWNER'S MANUAL 2015 |
17
SPARK