Advertisement
Set/reset the system in mute urd operatlng modes bv pressing the upper
round button on the remote control hand-held urut. This is a togte control,
which changes the state from one to the other each f,me rt is pressed.
o
If the system is in mute, pressing the up arro\r' to increase the volume will
reset the system and put it into operatrng mode. The down arrow, however,
will not impact the mute state.
o
Set and reset the preamp to phase reversed mode by pressutg the lower round
button.
\[4een you first press the buttons on the remote control unig there is a delay of a
iew seconds (about 2-3 seconds) before the preamplifier's completes the
processing of the slpal sent by the remote. Wait for the response from the
preamplifier before pressing another button on the remote unit. Dunng this
processing period selection of remote funcnons will be rgnored.
1 .
2.
3.
4.
5 .
Fffitrg fie Batterbs to flrc Remote Gotrtnol
Two Phillips head screws hold on the back cover of the remote control.
Remove all screws with the correct tool to avoid dam4grng them (using #2
Phillips head screwdriver), and put them aside for re-installing later.
Tum the remote control over so that the cover drops into your other hand,
and put the cover aside with the screws. If the back cover for the remote
control is too trght to fall out after removing all the cover mounting screws,
hold the remote control loosely in your hand face up with your other hand
under the remote ready to catch the cover. Give the bottom of the front edge
a shaqp rap on a hard-protected surface - a m gdzine covering a table is
sufficient to do this with. The cover should dtop out after one or two raps.
Be carcful of the insidc cdges of t{re lumote, as t{rey can bc sharp.
Locate the battery holder and insert the two supplied AAA batteries in the
marked positrons, * to * and - to -.
Being carefi:l not to damage the cover of the remote shell, replace the back
cover and snap it into its exact positron. Replace the mounting screws, being
carefi:l not to over-tighten them, and the cover will settle into place.
Test the remote control functions and ensure that all the functions ^re
working correcdy. If the functrons are not working then check that the
batteries are in the correct mourting positions and that they are not stale. If
you still encounter problems then you should call the factory or your dealer.
TL5,5 Preamplifier Owney's tanual
vTt
7
Advertisement
