Maintenance - Giant hybrid power bicycle User Manual

Reset to factory setting
1. Press and hold the buttons (B) and (D) simulta-
neously until '00' blinks.
2. Press button (D) less than 2.5 seconds to enter
the reset mode.
3. Press button (D) twice for less than 2.5
seconds; the system will be reset to the initial
factory setting.
MotionAssist operation (RideControl City)
MotionAssist works only the speed under 6km/hr.
• Turn MotionAssist backward to increase the
assist speed.
• Turn MotionAssist forward to reduce the assist
speed.
Power assist setting
RideControl RideControl
Press button (D) to choose the Power assist level (E).
• NORMAL : Normal power assist.
• SPORT : High power assist. Gives the smallest
range
• ECO : Low power assist. Gives the maximum
range.
• OFF: For riding without power assist but with cy-
cle computer and light functions. (LED for power
assist setting will be off).
D B
B
D
26
Power assist setting
RideControl Sport/City with Full LCD Display
and LED RideControl
Press button (D1) to choose the higher Power assist
level (E).
Press button (D2) to choose the lower Power assist
level (E).
• NORMAL : Normal power assist.
• SPORT : High power assist. Gives the smallest
range
• ECO : Low power assist. Gives the maximum
range.
• OFF: For riding without power assist but with
cycle computer and light functions.
(LED RideControl of the LED for power assist
setting will be off).
8

Maintenance

Giant Hybrid uses plastic shells to cover the electrical parts, so it is forbidden to use excessive
water to wash the plastic. Use a soft cloth with a neutral solution to wipe the dirt off the plastic
shells. After that, wipe it dry with a clean soft cloth.
Do not wash these plastic components with water. When the internal electrical parts are de-
tected with water, the insulator may corrode which leads to power-leakage or other problems.
Do not use other soap solutions to wash these plastic components. Non-neutral solutions
may cause color-change, distortion, scratch etc.
Do not use high-pressure water or air hoses for cleaning. It can force water into electrical
components, which may cause malfunctioning.
Avoid leaving the bike outdoors
When not riding, keep the bike in a location where it will be protected from snow, rain, sun etc.
Snow and rain can cause the bike to corrode. The ultraviolet from the sun can fade the paint or
crack any rubber or plastic on the bike.
D1 D1
D2 D2
27