jWIN JX-CD335 Instruction Manual

jWIN JX-CD335 Instruction Manual

Portable audio cd player

Advertisement

Portable Audio CD player
Instruction Manual
JX-CD335
Please read this manual carefully before operating and save it for future reference.
Have a question? Please visit http://www.jWIN.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JX-CD335 and is the answer not in the manual?

Questions and answers

Summary of Contents for jWIN JX-CD335

  • Page 1 Portable Audio CD player Instruction Manual JX-CD335 Please read this manual carefully before operating and save it for future reference. Have a question? Please visit http://www.jWIN.com...
  • Page 2: Location Of Controls

    2. DC IN jack 8. PROG button 3. HEADPHONE jack 9. MODE button 4. VOLUME dial 10. STOP / POWER OFF button 5. CD OPEN button 11. PLAY / PAUSE II button I button 12. LCD screen - 1 - www.jWIN.com...
  • Page 3: Getting Started

    LCD screen, be prepared to replace the batteries. AC Operation Before operating the JX-CD335, make sure that the voltage on the unit corresponds to the voltage of your local area. Unravel the AC Line Cord; insert one end into a DC jack on the unit and the other end into a standard AC outlet.
  • Page 4: Programmed Play

    To play the entire CD repeatedly, press the MODE button repeatedly until “ ” appears. Press the PLAY / PAUSE II button if playback is stopped. • To cancel the Repeat Function, press the MODE button repeatedly until “ ” or “ ” disappears. - 3 - www.jWIN.com...
  • Page 5: Random Play

    Cleaning the Cabinet Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. - 4 - www.jWIN.com...
  • Page 6: Specifications

    When the instructions in this manual are followed, this unit should function properly. However, if any of the following difficulties occur and cannot be corrected by the user or if a problem arises that is not mentioned here, please contact jWIN Customer Service or a qualified service technician. SYMPTOM CAUSE SOLUTION Dead or weak batteries.
  • Page 7: Troubleshooting Guide

    4-8 hours. normally. Remove batteries and AC adapter. Buttons do not Electronic or static error Wait a few seconds and re-insert. work. caused circuitry to lock. Make sure batteries are fresh or adapter has power. - 6 - www.jWIN.com...
  • Page 8 TEL: 866-807-5946 www.jWIN.com © 2009 jWIN Electronics Corp. All rights reserved. No portion of this printed material or product enclosed herewith including design, shape and graphics, may be reproduced or transmitted in any form without prior written consent of jWIN Electronics Corp. by any means, electronic or mechanical, including photocopying, recording or use of an information storage and retrieval system.

Table of Contents