Vertex Standard VXR-7000 Operating Manual page 7

Pin 13: GND
Chassis ground for all logic levels and power
supply return.
Pin 14: GND
Chassis ground for all logic levels and power
supply return.
Pin 15: N.C. ( No connection. )
Pin 16, 17, 18, & 19: REMOTE CH DATA
[ Logic Inputs D3, D2, D1, and D0 ] ( Active Low )
These inputs are internally pulled up to 5-V DC.
When pulled low by an external device, they se-
lect one of the 16 pre-programmed repeater oper-
ating channels. The logic truth table below shows
the combinations for selecting all 16 channels.
In the truth table, "1" represents no connection,
and "0" represents a ground connection on the
pin.
The channel selection logic is not inhibited while
the transmitter is keyed: the repeater will change
frequency when instructed, even while transmit-
ting.
Avoid voltage in excess of 5 V on these pins or
internal damage to the microprocessor on the re-
peater CNTL Unit may result.
Pin 16
Channel
( D3 )
1 1
2 1
3 1
4 1
5 1
6 1
7 1
8 1
9 0
10 0
11 0
12 0
13 0
14 0
15 0
16 0
VXR-7000 FM Repeater Operating Manual
Pin 17 Pin 18 Pin 19
( D2 ) ( D1 ) ( D0 )
1 1 1
1 1 0
1 0 1
1 0 0
0 1 1
0 1 0
0 0 1
0 0 0
1 1 1
1 1 0
1 0 1
1 0 0
0 1 1
0 1 0
0 0 1
0 0 0
ACC Connector Port
Pin 20: GND
Chassis ground for all logic levels and power
supply return.
Pin 21: A-OUTPUT [ Logic Output ] ( Active Low )
This open collector logic output is pulled low
when the front panel's ACCESSORY key is
turned on. It can sink approx. 10 mA when active.
Pin 22: RXD LOW
[ Digital Output for DATA Communications ]
( 300 ~ 3,000 Hz )
This pin is an output for low speed receiving data
signals, with the data being extracted after the
de-emphasis and low pass filter stages.
Pin 23: RXD HI
[Digital Output for DATA Communications]
This pin is an output for high speed receiving
data signals, with the data being extracted im-
mediately after the discriminator prior to any de-
emphasis).
Pin 24: TXD LOW
[ Digital Input for DATA Communications ]
( 300 ~ 3,000 Hz )
This pin is intended to be used as a low speed
digital data signal input to the repeater. This
digital data signal is injected before transmitter
pre-emphasis and limiting stage, so excess signal
input levels are clipped.
Pin 25: TXD HI
[ Digital Input for the DATA Communications ]
This pin is intended to be used as a high speed
digital data signal input to the repeater. This digi-
tal data signal is injected after transmitter splatter
filter stage.
5