Hitachi 32PD5000 Service Manual page 25

Item COLOR TEMPERATURE ADJUSTMENT -PC
Applicable Model
Preparation
(1) Set CRT COLOR ANALYZER at the center of
the screen panel.
(2) Input the full-white raster signal to RGB2 D-sub
terminal and select RGB2-RGB.
Signal condition
VGA (75)
Video level: 0.7Vp-p
Setup level: 0V
(3) Set the display area to "Full".
(This item must be done after the same
adjustment for VIDEO mode.)
32PD5000/42PD5000 (PW1)
42PD5000MA, 42PD5000TA, 32PD5000TA
Procedure
[Adjustment of Cool mode]
(1) Enter the service adjustment mode, and confirm
that No.12(R), 13(G) and 14(B) are all 255. If the
some data are not, set to 255.
(2) Adjust the color temperature by way that reduces
the one or two data in No.12, 13 or 14.
(Note: At least one of them should be 255 after
adjustment.)
<Specification>
Color Temperature (Cool) for PC
12000K
[Adjustment of Normal, Warm, Black/White mode]
(3) Set the adjusted value of COLOR TEMP. ADJ.
-VIDEO (Normal, Warm, Black/White mode; Adj No.
3, 4, 5, 6, 7, 8, 9, 10, 11) to Adj No. 15, 16, 17, 18,
19, 20, 21, 22, 23.
[at VIDEO]
No. 3 data
No. 4 data
-
-
No.11 data
<Specification>
Color Temperature (Normal) for PC
9300K
<Specification>
Color Temperature (Warm) for PC
6500K
<Specification>
Color Temperature (B/W) for PC
5400K
25
x=0.268 0.005
y=0.283 0.005
[at PC]
No.15 data
No.16 data
-
-
No.23 data
x=0.285 0.005
y=0.293 0.005
x=0.314 0.005
y=0.327 0.005
x=0.335 0.005
y=0.343 0.005