Black Tank Flush System (If Equipped); San-T-Flush Operation (Using Sanitizing Bottle Fivm Kit) (If Equipped) - Fleetwood American Eagle User Manual

Plumbing Systems and Holding Tanks
Black Tank Flush System
(If Equipped)
The black water holding tank is equipped with
rinsing spray heads that will aid in the removal
of sewage residue from the interior of the hold-
ing tank. To operate the tank flushing system,
follow the procedures for Draining The
Holding Tanks in this chapter. After dumping
the gray water tank proceed as follows:
1. With the dump valves open, attach a garden
hose to the black tank flush inlet connec-
tion.
2. Turn on water supply to garden hose and
allow the water to mn for approximately
three minutes to flush tank.
3. Turn off water supply to garden hose.
4. Remove hose from black tank flush inlet
connection and store hose.
5. Rinse ont the sewer hose with fi-esh water
and remove the sewer hose fi'om the dump
station.
6. Replace sewer or dump station covers.
7. After rinse water has thoroughly drained
from the black tank, close the knife valve
and replace the termination cap. If you are
parked at a site with a semipermanent
sewer hookup, keep the black water knife
valve closed to allow the waste level to
build up. The outlet will probably clog if
you leave the knife valve open continually.
Run enough water into the tank to cover
the bottom. This will aid the break up of
solid wastes. It is important to keep at least
20 gallons of water with deodorizer in the
black water tank at all times.
San-T-Flush Operation
(Black and Grey Tank Flush System)
(Using sanitizing bottle from kit)
(If Equipped)
1. Dump holding tanks in the usual manner at
an approved station.
2. Leave dump valves open.
07-6
3. Attach garden hose to San-T-Flush
attachment.
4. Remove clear plastic bottle.
5. Place one (1) waste liquefier tablet into
screen.
6. Replace the bottle. Hand tighten.
7. Hook water hose to inlet side of the sani-
tizing bottle cover.
8. Connect the male disconnect to the San-T-
Flush valve (yellow handle). Turn the
valve to "BLACK TANK."
9. Flush black tank until tablet is 2/3 dissolved.
10. While water is mnning, turn the San-T-
Flush valve to "GREY WATER TANK"
and flush until the tablet is dissolved.
11. Turn San-T-F1ush valve to "BLACK
TANK."
12. Remove San-T-F1ush attachment and
garden hose.
13. Remove the sewer hose and cap the outlet.
14. Rinse out the sewer hose with fresh water
and remove the sewer hose from the dump
station.
Replace sewer or dump station covers.
Please ... Practice good housekeeping when
drainillg wastes at a campsite or disposal sta-
tiOIl. Leave the site ill good order. Above all, do
Ilot pollute.
A
CAUTION
The sewer drain valve must be open when using the
black tank flush inlet.
A
CAUTION
Do not use the same hose you use for filling the
potable water tank, or for connection to the city water
inlet. This is especially true if you the connect the
quick connect hose to the typical rinsing hoses at
most dumping stations. Use of a different hose will
insure that you will not contaminate your fresh water
supply.